aboutsummaryrefslogtreecommitdiff
path: root/tests/data
AgeCommit message (Collapse)Author
2007-11-23Revert last change since it breaks running the test suiteYang Tse
when builddir is different from srcdir.
2007-11-23Improve chance of running runtests.pl from outside theYang Tse
source tree 'tests' directory
2007-11-05Added some keywordsDan Fandrich
2007-11-01Added test case 1014 to compare curl-config --features with curl --versionDan Fandrich
2007-11-01Added test case 1013 to check that curl-config --protocols matches theDan Fandrich
protocols listed in curl --version
2007-10-29Added test case 546 to check that subsequent FTP transfers work after aDan Fandrich
failed one using the multi interface
2007-10-27Fixed the 2000-series tests so that the downloaded data is actually checkedDan Fandrich
2007-10-26Fixed the test case to create only a single test file, which is all theDan Fandrich
test harness supports.
2007-10-25Disable valgrind for this test to avoid the rlimit = soft rlimit problemDan Fandrich
found by Michal Marek.
2007-10-25Added test case 2004.Dan Fandrich
Disable valgrind in test case 1004 due to a libtool bug.
2007-10-25Allow test server to handle binary POSTs.Patrick Monnerat
Tests 35, 544 545 added: binary data POSTs.
2007-10-25Fixed a TFTP memory leak. Enabled test 2003 to verify this.Daniel Stenberg
2007-10-24Fixed the test TFTP server to support the >10000 test number notationDan Fandrich
Added test cases 2002 and 2003 (the latter disabled for now)
2007-10-24enable 2000 and 2001Daniel Stenberg
2007-10-24Added test cases 2000 and 2001 which test multiple protocols using theDan Fandrich
same easy handle Fixed the filecheck: make target to work outside the source tree
2007-10-12Fixed a couple of typos that messed up the tests.Dan Fandrich
2007-10-12Added some <keywords> sections and use some key words more consistently.Dan Fandrich
2007-10-04I enabled test 1009 and made the --local-port use a wide range to reduce theDaniel Stenberg
risk of failures.
2007-10-04Kim Rinnewitz reported that --local-port didn't work with TFTP transfers.Daniel Stenberg
This happened because the tftp code always uncondionally did a bind() without caring if one already had been done and then it failed. I wrote a test case (1009) to verify this, but it is a bit error-prone since it will have to pick a fixed local port number and since the tests are run on so many different hosts in different situations I add it in disabled state.
2007-10-02known bug #46: chunked-encoded CONNECT responses from a http proxy now works.Daniel Stenberg
Added test case 1008 to verify. Note that #47 is still there.
2007-09-30Added test536 that was accidentally missing. I also wrote up a new makefileDaniel Stenberg
target called 'filecheck' so that if you run 'make filecheck' in this directory it'll check if the local files are also mentioned in the Makefile.am so that they are properly included in release archives!
2007-09-30Alex Fishman reported a curl_easy_escape() problem that was made theDaniel Stenberg
function do wrong on all input bytes that are >= 0x80 (decimal 128) due to a signed / unsigned mistake in the code. I fixed it and added test case 543 to verify.
2007-09-26Philip Langdale provided the new CURLOPT_POST301 option forDaniel Stenberg
curl_easy_setopt() that alters how libcurl functions when following redirects. It makes libcurl obey the RFC2616 when a 301 response is received after a non-GET request is made. Default libcurl behaviour is to change method to GET in the subsequent request (like it does for response code 302 - because that's what many/most browsers do), but with this CURLOPT_POST301 option enabled it will do what the spec says and do the next request using the same method again. I.e keep POST after 301. The curl tool got this option as --post301 Test case 1011 and 1012 were added to verify.
2007-09-26Max Katsev reported that when doing a libcurl FTP request withDaniel Stenberg
CURLOPT_NOBODY enabled but not CURLOPT_HEADER, libcurl wouldn't do TYPE before it does SIZE which makes it less useful. I walked over the code and made it do this properly, and added test case 542 to verify it.
2007-09-24Immanuel Gregoire fixed KNOWN_BUGS #44: --ftp-method nocwd did not handleDaniel Stenberg
URLs ending with a slash properly (it should list the contents of that directory). Test case 351 brought back and also test 1010 was added.
2007-09-20Added variable substitution to the <verify><file> section.Dan Fandrich
Made a few more tests work remotely.
2007-09-18Use double quotes in command lines for consistency.Dan Fandrich
2007-09-18IPv6 is a required feature for these two tests, even if it's not obvious.Dan Fandrich
2007-09-17Fixed the required server entryDan Fandrich
2007-09-17Changed some FTP tests to validate the format of the PORT and EPRT commandsDan Fandrich
sent by curl, if not the addresses themselves.
2007-09-17Made the directory postprocessor more forgiving of input directory formatDan Fandrich
2007-09-15Michal Marek made libcurl automatically append ";type=<a|i>" when using HTTPDaniel Stenberg
proxies for FTP urls.
2007-09-14Replaced 127.0.0.1 with %HOSTIP where possibleDan Fandrich
2007-09-11Daniel S (12 September 2007)Daniel Stenberg
- Bug report #1792649 (http://curl.haxx.se/bug/view.cgi?id=1792649) pointed out a problem with doing an empty upload over FTP on a re-used connection. I added test case 541 to reproduce it and to verify the fix. - I noticed while writing test 541 that the FTP code wrongly did a CWD on the second transfer as it didn't store and remember the "" path from the previous transfer so it would instead CWD to the entry path as stored. This worked, but did a superfluous command. Thus, test case 541 now also verifies this fix.
2007-09-07Added test case 1007 to test permission problem when uploading with TFTPDan Fandrich
(to validate bug #1790403).
2007-08-30Added more accurate error code returns from SFTP operations. Added testDan Fandrich
case 615 to test an SFTP upload failure.
2007-08-30Renamed several libcurl error codes and options to make them more generalDan Fandrich
and allow reuse by multiple protocols. Several unused error codes were removed. In all cases, macros were added to preserve source (and binary) compatibility with the old names. These macros are subject to removal at a future date, but probably not before 2009. An application can be tested to see if it is using any obsolete code by compiling it with the CURL_NO_OLDIES macro defined. Documented some newer error codes in libcurl-error(3)
2007-08-24Bug report #1779054 (http://curl.haxx.se/bug/view.cgi?id=1779054) pointedDaniel Stenberg
out that libcurl didn't deal with large responses from server commands, when the single response was consisting of multiple lines but of a total size of 16KB or more. Dan Fandrich improved the ftp test script and provided test case 1006 to repeat the problem, and I fixed the code to make sure this new test case runs fine.
2007-08-23Added test case 1005 to test excessively-long replies spread out overDan Fandrich
multiple lines (similar to test case 1003).
2007-08-23Added test1004 to validate a previous fix for a memory leak when anDan Fandrich
empty proxy server is selected.
2007-08-22Bug report #1779054 (http://curl.haxx.se/bug/view.cgi?id=1779054) pointedDaniel Stenberg
out that libcurl didn't deal with very long (>16K) FTP server response lines properly. Starting now, libcurl will chop them off (thus the client app will not get the full line) but survive and deal with them fine otherwise. Test case 1003 was added to verify this.
2007-08-17remove stupid comment since there's no content in this test caseDaniel Stenberg
2007-08-17Robson Braga Araujo filed bug report #1776235Daniel Stenberg
(http://curl.haxx.se/bug/view.cgi?id=1776235) about ftp requests with NOBODY on a directory would do a "SIZE (null)" request. This is now fixed and test case 1000 was added to verify.
2007-08-17some keywords for future stats/coverage checksDaniel Stenberg
2007-08-17Moved the 5320 and 5322 into the 1000-series instead which is a documentedDaniel Stenberg
range. They are about FTP but the 100-199 range is full.
2007-08-17Song Ma provided a patch that cures a problem libcurl has when doing resumeDaniel Stenberg
HTTP PUT using Digest authentication. Test case 5320 and 5322 were also added to verify the functionality.
2007-08-09There's no need to ignore the User-Agent for this test.Dan Fandrich
2007-08-02Dmitriy Sergeyev reported a regression: resumed file:// transfers brokeDaniel Stenberg
after 7.16.2. This is much due to the different treatment file:// gets internally, but now I added test 231 to make it less likely to happen again without us noticing!
2007-07-22Added test case 354 that makes a simple FTP retrieval without password, whichDaniel Stenberg
verifies the bug fix in #1757328.
2007-07-21test and verify curl -I on a single FTP file somewhat more than beforeDaniel Stenberg